Flow Form Clear
Double wall clear thermoplastic tubing that prevents failures due to corrosion, vibration and strain on electrical and many other connections.
Description
Outer wall shrinks –provides strength, rigidity, abrasion- and chemical resistanceInner wall melts –for a splash- and moisture-resistant seal (not intended for full immersion in fluids)Rugged protection against abrasion, vibration, and flexingExcellent strain relief and insulation of weak pointsClear –easy visual inspectionRoHS compliant
Additional information
| Color | Transparent |
|---|---|
| Content | 10 PC x 19.1 mm 10 PC x 25.4 mm 10 PC x 12.7 mm 10 PC x 9.5 mm 10 PC x 3.2 mm 10 PC x 6.5 mm 10 PC x 4.8 mm |
Application
Encapsulates components, splices, and terminations where moisture resistance and mechanical protection are required.Inner encapsulant melts and flows to fill surface irregularities of the substrate. While still hot, the tubing can be blocked to form a wire breakout. Provides strain relief on robotic applications. Insulates tool handles from electric shock.Protects chains from corrosion. Apply on cord extremities to prevent them from fraying.Typical applications include :Insulates, bundles and waterproofs a wide range of connectionsInsulates and protects electrical terminals and connectorsProtects welding cables, equipment, wiring and lightsInsulates tool handles from electric shock Protects chains from corrosion Prevents cord extremities from frayingSeals and protects flexible hosesProtects labels or printing on cables
Manuals
1. Always select the largest size that will shrink snugly over the component to be covered.2. Cut a piece of Flow Form tube. It should be long enough to cover the connection in excess at both sides of the connection. 3. Clean the connection with Electric Cleaner and allow flashing off.4. Insert one part of the unassembled connection into the Flow Form tube before closing the connection and slide the Flow Form tube over the connection until it’s fully covered.5. Apply heat with Blazer Torch evenly to the Flow Form tube to allow shrinkage, starting from the middle to both extremities.6. Stop applying heat when the inner encapsulant starts melting out from both extremities of the Flow Form tube and allow to cool down.
Your challenge – our solutions
