One Shot 2

A very powerful and fast acting cleaner for the air induction side of fuel injection systems and carburettors –Toluene free.


Category

Description

High pressure spray –Blasts off dissolved varnish, gum & grease
Fast drying –Leaves no oily film
Safe on catalytic converters & oxygen sensors –No comebacks
Suitable for all petrol engines –Reduces inventory
Frees carburettor valves, linkages, thermostat coil, choke pistons, automatic choke coils –Engine runs smoothly & efficiently

Additional information
Color Transparent
Content 500 ml

Application

Originally sold as a carburettor cleaner, however with the advancement of fuel injection on vehicles, KENT One Shot 2 has found a new niche as perhaps the best cleaner for the air induction side of engine management systems in the market. It is a very powerful cleaner that is extremely efficient at removing residue from throttle bodies, PCV valves and other injection components. Vehicles are able to run on KENT One Shot 2, so the product can be safely sprayed into these areas whilst the vehicle is running, therefore flushing all contaminants through the exhaust system. With customers specialising in older vehicles, KENT One Shot 2 is a 1st class carburettor cleaner.

Manuals

Injection systems:
1. Remove no-load valve and rinse with KENT One Shot 2.
2. With engine warm and running, disconnect air intake as close to injection system as possible. Spray One Shot 2 into intake pipe for 5 – 10 seconds.
3. Repeat if necessary, reconnect air intake.
Carburettor systems:
1. With engine warm, remove air cleaner and spray into carburettor throat to free choke valve.
2. Block off and disconnect fuel supply and allow float chamber to run dry.
3. Fill float chamber with KENT One Shot 2 and allow to soak for 5 – 10 minutes.
4. Start engine and run at various revs to clean system, replenish float chamber with KENT One Shot 2 for one minute then run until empty.
5. Reconnect fuel lines and spray all other linkages and control valves on the carburettor.
WARNING: Beware splash-back into eyes. Do not spray onto exposed painted surfaces.

Your challenge – our solutions

Improve & Protect

Additives
Lubricants

More info

Bond & Seal

Bond & Seal

Adhesives
Sealants
Adhesive tapes

More info

Color & Coat

Color & Coat

Levelling compounds
Primers
Fillers
Coatings
Paints

More info

Clean & Care

Cleaners
Polishes & Sealants
Care products
Disinfection & Odour remover

More info

Apply & Equip

Apply & Equip

Accessories
Equipment
Consumables

More info