Premium PU Repair 1.5
A very fast curing, easy to use structural 2-part polyurethane adhesive specially designed for small, quick, durable bonding and repairs on plastics and many other substrates.
Description
Bonds most plastics, metals, wood, etc. –universal1.5 minute open time –fast curingExcellent filling properties –doesn’t sag while curingDoesn’t bubble while curing –neat finishDoesn’t peel off –easy sandingVery good flexibility –doesn’t crackUltra small mixing nozzles –less waste of product
Additional information
| Color | Black |
|---|---|
| Content | 50 ml |
Application
Premium PU Repair 1.5 minute allows small repairs to be made in a very limited time, such as filling small cracks, holes and scratches, but also small assembly operations. Bonds most plastics, metals, wood, etc.
Manuals
1. Clean repair area with KENT Acrysol or Soft Surface Cleaner and allow to dry.2. Using 80 grit wet / dry disc, sand both the surrounding areas of the repair.3. Re-clean repair areas with KENT Acrysol or Soft Surface Cleaner and allow to dry.4.For more difficult-to-bond plastics, apply KENT Plastic Adhesion Promoter in several thin cross layers to both sides of the repair and allow to dry.5. Place the opened cartridge in the dispenser and purge until material starts to flow from both cartridge chambers. Fit the supplied mixer tip to the cartridge, extrude and dispose of first 2 – 3 cm of product then directly proceed with the repair. The material in the mixer will become very difficult or impossible to dispense at about 45 seconds after starting to extrude, in which case a new mixer tip should be used.6. For an assembly operation, bring both components together and apply uniform pressure within 60 – 80 seconds. Clamping time is approx. 5 minutes at 23°C, after which a tensile strength of 1.5 N/mm² is achieved.
For a scratch or crack repair, spread the bead over the scratch or the crack within 60 – 80 seconds respecting a thickness of max. 3 – 4 mm. The thinner the layer, the slower the product will cure.7. After 10 – 15 minutes depending on temperature, sand the repair area to a smooth finish if required. Avoid excessive speed, care must be taken not to overheat the plastic. 8. Allow 1 hour at 23°C between product application and painting. More waiting time is needed at lower temperatures.9. Uncured material may be removed from tools and equipment with KENT Acrysol. Within the first hour, the repair can be removed by peeling it off. Once fully cured, it’s almost impossible to remove.
Your challenge – our solutions
