Rapid Bond
Two-components methacrylate adhesive offering extreme levels of strength, speed and flexibility for the structural bonding of modern materials. 5 or 15 minutes working time.
Description
High shear strength –ideal for use on structural joining of metals, composites and plasticsPrimerless bonding for most metals, including steel and aluminum –minimal surface preparationExcellent resistance to hydrocarbons, acids and salt solutions –wide range of application possibilities in harsh environments, excellent aging propertiesRoom temperature cured –does not attack surfaces, no yellowing and fast cure with rapid strength buildLatest acrylic elastomer chemistry –remains flexible and allows filling large bond gap
Additional information
| Color | White Black |
|---|---|
| Content | 15min / 220 ml 5min / 50 ml 5min / 220 ml |
Application
Ideal for structural joining of metals, (including aluminium, stainless steel) GRP, composites, plastics, (includes ABS, acrylics, vinyl, PVC, polycarbonates), epoxy laminates and gel coats where high impact strengths are needed.Typical uses include: door skins, bumper assemblies, automotive spoilers, vents, housings, mouldings, signs and displays.
Manuals
1. Abrade surface to be bonded with medium grit paper, then wipe clean.2. Cleaning with KENT Acrysol or Soft Surface Cleaner is preferred.3. Balance cartridge, then attach correct nozzle and insert into applicator gun.4. Extrude first 20 mm of KENT Rapid Bond and discard to ensure a proper mix has been achieved in the nozzle.5. Apply KENT Rapid Bond to one surface only, press parts together with finger pressure only. Ensure that the bond gap is completely filled when the two parts are joined. Allow for squeeze out at the edges of the bond, to ensure even filling.6. Carefully clamp parts, if required, to secure the bond and prevent joint movement while the adhesive cures. Do not apply excessive pressure that may cause an excessively thin bond line.7. Use a sharp paring tool to remove excess adhesive, partially cured adhesive can be removed with sharp knife, cured material can be removed by sanding / scraping.8. If stored for later usage, remove the nozzle and ensure that both parts of the product will not be in contact to avoid clogging. Reapply the cap.N.B.: Always use in a well-ventilated area. Apply KENT Rapid Bond in beads across surface of larger areas.
Your challenge – our solutions
