Rubber Guard
A heavy duty, coarse textured underseal that protects against corrosion and stone chipping.
Description
Heavy bodied –Excellent coverage, even with one coat Unique blend of resins –Does not harden or crackEasy aerosol application –Can be used anywhereExcellent adhesion –Does not require primerDoes not contain bitumen –No discoloring & no crackingWide temperature range -40º C to +135ºC –Withstands extreme conditionsOver paintable –Compatible with most paint systems
Additional information
| Color | Black |
|---|---|
| Content | 451 ml 577 ml |
Application
Rubber Guard is designed as an alternative for underbody sealants and stone chip coatings which have to be applied by air gun. Rubber Guard is able to give different styles of finish according to thickness of coat and distance sprayed from.It is particularly good at recreating the light stone chip finish found on the lower edge of sill & front panels on many vehicles. It is also good as a sealant for covering welding repairs and it withstands harsh treatments in wheel arches and underbody areas.For a safe over painting, apply several layers and allow to flash off in between.
Instructions
1. Remove rust, dirt, oil and other contaminants. The surface must be clean and dry.2. Shake vigorously until mixing ball breaks loose. Then shake for one minute. Repeat shake procedure after each one minute of spraying.3. Hold can approximately 30 cm from surface and spray with a sweeping motion, building with light coats. Allow previous coat to flash off before applying new one.4. After each use, clean valve by turning can upside down and spray until clear.5. Clean off overspray with KENT Acrysol.6. If over painting, Rubber Guard must be fully dried before applying paint (minimum 2-3 hours, preferably overnight).
Your challenge – our solutions
