Screenfix 150 + Screenprep Wipe
Screenfix 150 is an isocyanate free, high modulus, low conductive windscreen adhesive providing a 150 minute drive away time for vehicles with twin air bags.
Description
Single component adhesive –easy application either by air gun or hand caulking gunNo pre-heating of product –more flexible application and no time wasted on pre-heating cyclePrimerless system –no time wasted on priming and activationCrash tested to FMVSS 212 –recognized performances150 minute drive away with 2 air bags –fast turnoverHigh green strength –no clamping required and no time wastedGood dielectric resistance characteristic –suitable for modern glass with integrated aerialsIsocyanate free –no health risks, safe to use
Additional information
| Color | Black |
|---|---|
| Content | Screenfix 150 + Screenprep Wipe |
Application
Specifically developed for the automotive industry, Screenfix 150 is the ideal product to use for the bonding of direct glazed glass in vehicles. Screenfix 150 is suitable for all bonded front, rear and side glass in vehicles. Screenfix 150, due to its fast (2.5 hours) drive-away time is ideal for front windscreen replacement where the vehicle is required back on the road in the same day. Screenfix 150 is also a very good general adhesive and will bond metal, glass, wood, most plastics, fiberglass, rubber, ceramics, concrete, brick and polystyrene to themselves and one another.
Manuals
1. When using the short method, remove existing sealant until a flat bead approximately 4 mm high remains. 2. Use the KENT SCREENPREP WIPE to clean and prepare the ceramic layer of the windscreen – ensuring the product dries fully.3. Apply KENT SCREENFIX to the pinchweld on top of the existing sealant in a triangular bead of 9 to 11 mm high.4. Insert the new windscreen within 10 minutes.5. Remove any excess of KENT SCREENFIX with a clean, dry cloth – do not use solvents.6. When applying KENT SCREENFIX direct to painted or bare metal as per long method, always use KENT MS PREP as directed. Apply a triangular bead up to 17 mm high as necessary.
Your challenge – our solutions
